Installation Guide

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting Cube Geometric Shaped Frost Pressed Glass Wall Washer Sconce

1.7

Installation Instructions for

Cube Wall

700WSCUB_

920WSCUBE

GENERAL PRODUCT INFORMATION:

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

WALL COLLECTION

C AUTION — RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Remove the Mounting Plate from

the Sconce Base

SET SCREW

ALLEN WRENCH

With the Allen wrench provided, back out (do not fully

remove) the set screw at the base of the sconce.

Loosen the sconce mounting plate by pulling the

bottom of the mounting plate out and then down.

Remove the mounting plate by pushing the transformer

and wires through the mounting plate center hole.

1A 1B

Summary of content (4 pages)

PAGE 1
920WSCUBE Installation Instructions for Cube Wall 700WSCUB_ 1.7 WALL COLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. C AUTION — RISK OF FIRE This product is suitable for damp locations. This product requires installation by a qualified electrician. Before installing be sure to read all instructions and TURN THE POWER TO THE ELECTRICAL BOX OFF.
PAGE 2
Mount the Sconce to the Electrical Box 2A 2C TAB TOP OF THE SCONCE BASE 1 2 #8-32 SCREW MOUNTING PLATE TOP TAB 8 3 MOUNTING PLATE 7 1 TAB 1 Make sure the two tabs on the mounting plate are positioned at the top and bottom of the plate. 7 Place the transformer and all wires properly inside the electrical box. 2 Line up two mounting plate slots with the two electrical box holes. 8 Hook the top of the sconce base over the mounting plate top tab.
PAGE 3
Replacing the Lamp CAUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture by turning the wall switch off. Use MAX 35 Watt, Bi-Pin Halogen Lamp. 3A 3C LAMP SHIELD 1 LAMP SOCKET 4 NOTE: Use only your fingers and a soft cloth to 3 Handle the new replacement lamp with a soft cloth to prevent the natural oils on the fingertips from collecting on the lamp. This will help extend the life of the lamp.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Two Tips For Prolonging Halogen Lamp Life – Do not remain in light if skin feels warm.