Installation Guide

4
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!
HUB
TAB
AIRCRAFT
CABLE
While supporting the glass shade with one hand, with
the other hand feed the aircraft cable through the tabs
into the hub.
Carefully, pull the aircraft cable behind the hub to raise
the glass shade. Make sure that the glass shade is not
touching the lamps, but it is high enough to cover the
lamps.
To lower the glass shade, push the tabs in and pull the
aircraft cable down.
When the desired position achieved, trim the excess
aircraft cable coming behind the hub for a nice and neat
look.
7
8
9
10
GLASS SHADE
7
8
NOTE: To replace the lamps, simply reach the lamp
from top of the glass shade. DO NOT REMOVE THE
GLASS SHADE.
NOTE: Make sure to support the glass shade while
adjusting the aircraft cables to position it in place as
described in the steps below.
9
10
5C