Installation Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Paravo Single Light 15-1/8" Wide Line-Voltage Suspension Pendant with an Ultra Smooth Fiberglass Shade

Installation Instructions for

700 PRVP_TD

920TDPARAVO

PENDANTS

Paravo Pendant

1.0

Install the Fixture

Separate the crossbar assembly from the canopy by

unscrewing the decorative nut from the crossbar

assembly.

Loosen ( ) set screw in the strain relief.Do Not Remove

Feed fixture cord though decorative nut, canopy and

crossbar assembly.

Adjust the fixture height (from bottom of the fixture

shade to top of the canopy) by moving the crossbar

assembly up or down.

When the desired height is achieved, tighten the set

screw on the strain relief.

CORD

CROSSBAR

ASSEMBLY

CROSSBAR

ASSEMBLY

CANOPY

DECORATIVE NUT

CROSSBAR

ASSEMBLY

CORD

DECORATIVE NUT

CANOPY

STRAIN

RELIEF

SET SCREW

STRAIN

RELIEF

SET SCREW

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

Incandescent version may be dimmed with a standard

incandescent dimmer.

LED version may be dimmed with a LED or TRIAC dimmer.

Consult lamp manufacturer for additional information.

Summary of content (4 pages)

PAGE 1
920TDPARAVO Installation Instructions for Paravo Pendant 700TDPRVP_ 1.0 PENDANTS GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED or TRIAC dimmer. Consult lamp manufacturer for additional information.
PAGE 2
1D 1F 10 12 4" 9 11 6 7 8 Leave 6" of the cord behind the canopy for power connections. Cut the excess cord. 10 Connect the crossbar and the fixture ground wire to a suitable ground in accordance with local electrical codes. From the end of the cord, strip the insulation 4" using a sharp knife. Make sure not to nick the inner wires. 11 Connect the fixture neutral wire(white wire) to the Strip the end of the wires.
PAGE 3
Install the Diffuser and Lamp 2B 1C 2A METAL ARM 3 2 DIFFUSER THREADED HOLE SOCKET 2 Angle the diffuser into position and rest it evenly on the metal arms of the fixture. 3 Align threaded holes in glass with each metal arm. 1 LAMP 2C METAL ARM 4 C AUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture. DIFFUSER 4 Refer to fixture marking for lamp information. 1 Screw the lamp into the socket.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.