Installation Guide

ManualsBrandsTech Lighting ManualsCeiling FixturesTech Lighting Mulberry Large Round Desert Clay Fabric Shade Semi-Flush Mount Ceiling Fixture

1.5

Installation Instructions for

700TDMULFM_

920TDMULC

CEILING

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

This instruction shows a typical installation.

Mulberry Ceiling

Installing the Fixture

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

Unscrew and remove the knurled nut from the socket

assembly.

Feed the socket assembly wires through the shade

center bracket hole and the knurled nut.

Tighten the knurled nut completely to the socket

assembly exposed nipple.

KNURLED NUT

SOCKET ASSEMBLY

WIRES

SOCKET

ASSEMBLY NIPPLE

SHADE CENTER

BRACKET

KNURLED NUT

Summary of content (4 pages)

PAGE 1
920TDMULC Installation Instructions for Mulberry Ceiling 700TDMULFM_ CEILING GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard incandescent dimmer. This instruction shows a typical installation. Installing the Fixture C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture.
PAGE 2
1C 1E FIXTURE CANOPY SOCKET ASSEMBLY WIRES 9 4 EXPOSED NIPPLE 5 #8-32 SCREW 4 Feed the socket assembly wires through the canopy post. 5 Rotate the canopy clockwise to tighten the canopy post completely to the exposed nipple. 9 10 1D 6 8 10 CANOPY POST 7 NOTE: Use the provided universal round crossbar when the canopy holes do not line up with the electrical box holes.
PAGE 3
Installing the Lamps & Glass Disk 2B 2A 1 BUSHING NIPPLE LAMP SOCKET JAM NUT BOTTOM OF THE FABRIC SHADE 1 SOCKET LAMP CAP 2 Loosen the knurled nut and adjust the nipple height so the back of the cap is level with bottom of the shade. 3 Tighten the jam nut firmly against the bushing. 2C C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. SHADE PEG Use MAX 120 Volt, 75 Watt A19 (medium) base lamp with each socket.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.