Installation Guide

2.0

Installation Instructions for

700TDLEXP_

920TDLEXP

PENDANTS

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

Lexington Pendant

Install the Lamps

Screw the lamps into the sockets.

Use Volt, Watt

A21 (medium) base lamp with each

socket.

120 Volt, Watt A19 (medium)

base lamps (recommended) are

provided with the fixture.

MAX 120 150

100

SOCKET

LAMP

Attach the shade to the socket assembly before

installing the canopy.

Install the Shade

CABLE

Unscrew the cap from the top of the socket assembly

and slide the cap nut off the cable.

Feed the cable through the center of the shade support

until it rests on the end of the socket assembly.

Feed the cable through the center of the cap and screw

the cap back onto the socket assembly.

CAP

SOCKET

ASSEMBLY

SHADE

PAGE 1
920TDLEXP Installation Instructions for Lexington Pendant 700TDLEXP_ PENDANTS GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard incandescent dimmer. Attach the shade to the socket assembly before installing the canopy. Install the Shade Install the Lamps 1A 2A CABLE CAP SHADE LAMP 1 SOCKET SOCKET ASSEMBLY 1 Unscrew the cap from the top of the socket assembly and slide the cap nut off the cable.
PAGE 2
Install the Glass Disk 3B 3A SHADE PEG BUSHING 2 JAM NUT NIPPLE 1 BOTTOM OF THE FABRIC SHADE NIPPLE 3 CAP 1 Loosen the knurled nut and adjust the nipple height so the back of the cap is level with bottom of the shade. 2 Tighten the jam nut firmly against the bushing. CAP GLASS DISK 3 Remove the cap. 4 Place the glass disk onto the nipple and secure it against the shade pegs with the cap. NOTE: Do not over tighten the cap. Overtightening may break the glass and result in injury.