Installation Guide

Installation Instructions for

GENERAL PRODUCT INFORMATION:

This product is suitable for damp locations.

This product can be dimmed with a standard incandescent

dimmer.

Beacon

Install the Glass

PENDANTS - LINE VOLTAGE

1.0

700TDBCNP_

920TDBEAP

Line up the holes in the glass with the arms on the

socket base.

Place nylon washers on the thumb screws and screw

them into the arms on the socket base.

THUMB

SCREW

NYLON

WASHER

GLASS

STUD

Screw the lamp into the socket.

Use Type T9 Classic Edison

E26 base incandescent lamp.

MAX 30 Watt

Install the Lamp

CAUTION: To reduce the risk of a burn or electric

shock during relamping, disconnect the power to

the fixture.

SOCKET

LAMP

PAGE 1
920TDBEAP Installation Instructions for Beacon 700TDBCNP_ PENDANTS - LINE VOLTAGE GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can be dimmed with a standard incandescent dimmer. Install the Glass 1A NYLON WASHER Install the Lamp 2A STUD THUMB SCREW SOCKET GLASS 1 LAMP Line up the holes in the glass with the arms on the socket base. C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture.
PAGE 2
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2008 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.