Manualshelf

Installation Sheet

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting Zur 12" LED Adjustable Outdoor Wall Sconce with Button Photocontrol
12
2
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
2
1
With the provided Allen wrench, remove the set screws and o-rings on both sides of the fixture base.
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off). Warning: The
purple and gray wires are only used for 0-10v dimming. For all other applications, do not connect the gray and purple wires.
Properly place the driver, all wires, and wire nut connections into the fixture base.
Mount the fixture back onto the mounting plate and reinstall the set screws and o-rings (reversal of step 1A).
For wet locations, caulk around the fixture base with waterproof construction sealant.
To adjust the head angle, on each side of the head remove the screws with the O-ring to access the locking set screws.
NOTE: Maximum rotation of the fixture head is 240º
Loosen ( ) the locking set screws on each side and adjust the head to the desired angle. Re-tighten the locking set screwsdo not remove
and re-install the screws with the O-rings.
1A
Install the Fixture
4
3
6
5
7
ALLEN WRENCH &
SET SCREW
6
MOUNTING PLATE
4
9
8
11
10
10
12
5
7
DRIVER
11
12
12
SOCKET CAP
SCREW W/ O-RING
Note for In-Line Fuse equipped fixtures: in the case that the fixture is not operating correctly, make sure to check the fuse.
Warning: The purple and gray wires are only used for 0-10v
dimming. For all other applications, do not connect the gray
and purple wires.
Note for Photocell equipped fixtures: at initial power up,
the photocell must calibrate which will cause the fixture to
cycle on/off for a moment.