Installation Sheet

3
1G
COVER
10
Install the cover by sliding it back onto the fixture
making sure the lips of the cover are behind the driver
housing.
Secure the cover in place by tightening the set screws
with the provided Allen wrench.
11
10
DRIVER
HOUSING
SET SCREW
ALLEN
WRENCH
11
11
NOTE: Make sure the sealant is dry before
reinstalling the cover.
LIP
The angle markers can be adjusted independently. Open
and close the angle markers on the top and bottom of
the fixture to the desired beam angle.
Tighten the set screws on the sides of the angle markers
with the provided Allen wrench to lock them in place.
Adjust the Fixture
2A
1
ANGLE MARKERS
2
ALLEN
WRENCH
& SET SCREW
1 1
2