Installation Sheet

1.0

Installation Instructions for

Port Square Wall

700OWPRTS_

920OWPORTS

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product may be dimmed with a low-voltage electronic

dimmer or a 0-10V dimmer depending on the wiring

configuration.

Suitable for wet locations.

Install the Fixture

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

With the provided Allen wrench, remove the three

fixture screws.

Remove the mounting plate from the back of the

fixture.

FIXTURE

SCREW

MOUNTING

PLATE

OUTDOOR

Install the mounting plate with the inscribed “TOP”

oriented to the top of the junction box. Secure with the

two #8-32 screws provided.

#8-32 SCREW

ALLEN

WRENCH

Note: Some adjustment may be needed to

ensure the fixture is level.

PAGE 1
920OWPORTS Installation Instructions for Port Square Wall 700OWPRTS_ 1.0 OUTDOOR GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product may be dimmed with a low-voltage electronic dimmer or a 0-10V dimmer depending on the wiring configuration. Suitable for wet locations.
PAGE 2
1C 1D 6 4 5 7 4 Connect the ground wire to a suitable ground in accordance with local electrical codes. 5 Connect the black fixture wire to the hot power line wire with a wire nut. 6 Connect the white fixture wire to the neutral power line wire with a wire nut. 7 Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off). 8 Properly place all wires and wire nut connections into the electrical box.