Installation Sheet

1.0
Installation Instructions for
Gage 8/15/20 Wall
700OWGAG_
1
920OWGAGE
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed
utilizing compliant junction boxes.NEC
This product may be dimmed with a low-voltage electronic
dimmer or a 0-10V dimmer depending on the wiring
configuration.
Suitable for wet locations.
2
1
With the provided Allen wrench, back out (do not fully
remove) the set screws on both sides of the fixture.
Remove the mounting plate from the back of the
fixture.
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
OUTDOOR
1A
1
MOUNTING
PLATE
ALLEN WRENCH
SET SCREW
1
Prepare the Fixture
2A
1
While holding the backplate in place, remove the
backplate screws with the provided Allen wrench.
ALLEN WRENCH
BACKPLATE
1
1
Adjust the Position of the Backplate
(optional for 15 & 20 versions only)
BACKPLATE
SCREW

Summary of content (4 pages)