Installation Sheet

2
2B
FIXTURE BASE
#6-32 SET SCREW
1/16 ALLEN
WRENCH
3
GROOVE ON
GLASS SHADE
2
3
Place the glass shade into the fixture base until the
grooved section of the glass shade is completely inside.
Hold the glass shade in place and tighten all the #6-32
set screws with the 1/16 Allen wrench to lock the glass
shade in place.
NOTE: To replace the lamps, reverse section 2.
3
CAUTION: To reduce the risk of a burn or electric
shock during relamping, disconnect the power to
the fixture.
NOTE: The G9 lamp has an integral glass envelope
and is thus safe to be used without a lamp shield.
Use 120 Volt, Watt Type T4,MAX 40
G9 Base, Bi-Pin Halogen Lamp With
Each Socket.
NOTE: Use only your fingers and a soft cloth to
replace the lamp.
Push the lamps completely into the sockets.
LAMP
SOCKET
1
2A
1
Install the Lamps and Shade