Installation Sheet

ManualsBrandsTech Lighting ManualsCeiling FixturesTech Lighting Boxie Convertible 9" Wide Outdoor Flush Mount Ceiling Fixture / Wall Sconce

CEILING COLLECTION

Install the Fixture Base

While supporting the glass shade, loosen (Do Not

Remove) the four #6-32 set screws on fixture base with

the 1/16 Allen wrench.

Carefully remove the glass out of the fixture base.

#6-32 SET SCREWS

1/16 ALLEN

WRENCH

GLASS SHADE

MOUNTING BASE

Remove the mounting plate from the assembly by

unscrewing the two knurled nuts.

1.4

Installation Instructions for

Boxie Small

700BXS_

920BOXISM

GP I :ENERAL RODUCT NFORMATION

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is suitable for damp or wet locations.

This product can be dimmed with a standard incandescent

dimmer.

This product may be ceiling or wall mounted.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920BOXISM Installation Instructions for Boxie Small 700BXS_ CEILING COLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product can be dimmed with a standard incandescent dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
1E 1C 4 4 8 #8-32 SCREW 4 MOUNTING PLATE 8 #8-32 SCREW 8 Secure the mounting plate to the electrical box with the two #8-32 screws. NOTE: Install the mounting plate so that the mounting studs are parallel or perpendicular to the walls, this will ensure that the fixture is oriented to Mount the fixture base to the ceiling by reinstalling it on to the mounting plate and securing it tightly with the knurled nuts.
PAGE 3
Install the Lamp and Shade 2B 2A FIXTURE BASE #6-32 SET SCREWS 2 3 1 LAMP GROOVE ON GLASS SHADE SOCKET C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: The G9 lamp has an integral glass envelope and is thus safe to be used without a lamp shield. 1/16 ALLEN WRENCH 2 Place the glass shade into the fixture base until the grooved section of the glass shade is completely inside.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – A new halogen lamp may smoke slightly when it is used for the first time. This is perfectly normal; the protective coating is simply being vaporized. – Use this fixture indoors only. Two Tips For Prolonging Halogen Lamp Life – Do not look directly at the lighted lamp. – Do not remain in light if skin feels warm.