Installation Sheet

ManualsBrandsTech Lighting ManualsWall SconcesTech Lighting ModernRail 36" Tall Integrated LED Wall Sconce with 24v Remote Transformer Ceiling Canopy and Frosted Opal Glass Orb Shades

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture

Remove the canopy screws using the provided Allen

Wrench.

Remove the mounting plate from the canopy.

Two Person Installation Recommended

CANOPY

SCREW

MOUNTING

PLATE

ALLEN

WRENCH

1.0

Installation Instructions for

700MDWSRF_

920MDWALLS

MODERNRAIL

ModernRail Wall with Surface Transformer

Secure the mounting plate to the electrical box with the

#8-32 screws provided.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is dimmable with a low-voltage electronic dimmer.

This product is suitable for dry locations only.

This instruction shows a typical installation.

#8-32 SCREW

MOUNTING

PLATE

Summary of content (4 pages)

PAGE 1
920MDWALLS Installation Instructions for ModernRail Wall with Surface Transformer 700MDWSRF_ 1.0 MODERNRAIL GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is dimmable with a low-voltage electronic dimmer. This product is suitable for dry locations only. This instruction shows a typical installation.
PAGE 2
1D 1C MOUNTING PLATE 6 UPPER ARM 39" MARKED LOCATION BOSS ANCHOR SCREW ANCHOR 7 8 LOWER ARM 5 4 Using the diagram above, mark the anchor hole location for the lower arm onto the wall. The fixture measure 39" from the center of the upper arm to the center of the lower arm. 2 5 Verify that the mounting plate is level before continuing. 6 Line up an anchor tip with the marked location, and push the anchor into the wall up to the threads.
PAGE 3
D 3B 15 CANOPY SCREW DRIVER 15 9 8 CANOPY ALLEN WRENCH 15 CANOPY 8 9 10 Connect the black driver wire to the black fixture wire with a wire nut. 14 Neatly place all wires and wire nut connections inside the canopy. 15 Align the canopy holes with the mounting plate holes. Connect the red driver wire to the red fixture wire with a wire nut. Secure the canopy in place by tightening the canopy screws using the provided Allen Wrench. Neatly place the driver and wires inside the canopy.
PAGE 4
Install the Module and Shade 2A 2C RAIL MODULE MODULE SHADE 1 MODULE Separate the two halves of the module by unscrewing them from one another. 2B 3 Install the shade by screwing it into the base. Do not over-tighten. A maximum of 4 modules or 32W Max can be installed per rail. 4 Repeat steps 1-3 for remaining modules. RAIL MODULE MODULE 2 Install the two module halves onto the rail and secure in place by screwing them together.