Installation Sheet

CEILING COLLECTION

Install the Fixture

1.0

Installation Instructions for

Wynter Square Large (LED)

700FMWNTSL_-LED_

920FMWYNSL

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for wet locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This product may be ceiling or wall mounted.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

ALLEN

WRENCH

FIXTURE SCREW

FIXTURE BASE

With the provided Allen wrench, remove the four fixture

screws.

Remove the shade from the fixture base.

SHADE

Temporarily install the fixture base to the electrical box

with two #8-32 screws.

Mark the four anchor locations and uninstall the fixture

base.

#8-32 SCREW

PAGE 1
920FMWYNSL Installation Instructions for Wynter Square Large (LED) 700FMWNTSL_-LED_ 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
1F 1C FIXTURE SCREW 13 6 13 6 13 5 6 13 SHADE ANCHOR 5 At the marked location, push the anchor in up to the threads. 6 Screw the anchor the rest of the way in with a screwdriver. 13 ALLEN WRENCH Re-install the shade to the fixture base and secure it with the four fixture screws using the provided Allen wrench. 1G 1D 9 8 14 7 Connect the fixture to a suitable ground in accordance with local electrical codes. 8 Connect the black driver wire to the hot power line wire with a wire nut.