Installation Sheet

CEILING COLLECTION

Install the Fixture

1.0

Installation Instructions for

Wynter Round Medium and Small (LED)

700FMWNTR_-LED_

920FMWYNR

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp or wet locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This product may be ceiling or wall mounted.

This instruction shows a typical installation.

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Connect the fixture to a suitable ground in accordance

with local electrical codes.

Connect the black driver wire to the hot power line wire

with a wire nut.

Connect the white driver wire to the neutral power line

wire with a wire nut.

ALLEN

WRENCH

FIXTURE SCREW

FIXTURE BASE

With the provided Allen wrench, remove the two fixture

screws.

Remove the shade from the fixture base.

SHADE

PAGE 1
920FMWYNR Installation Instructions for Wynter Round Medium and Small (LED) 700FMWNTR_-LED_ 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp or wet locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
1C #8-32 SCREW #8-32 SCREW 6 Properly place the wires and wire connections into the electrical box. 7 Secure the fixture base to the electrical box with 2 #832 screws. 1D FIXTURE SCREW 9 9 ALLEN WRENCH 8 Align the screw holes on the shade to the holes in the fixture base and re-install the shade to the fixture base. 9 Secure the shade to the fixture base with the two fixture screws using the provided Allen wrench.