Installation Sheet

1.0
Installation Instructions for
Sopra Ceiling
700FMSPR
1
920FMSOPRA
2
1
Remove the mounting plate from the fixture base by loosening the set screws around the fixture base using the provided(not removing)
Allen wrench.
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line.
Connect the black fixture wire to the hot power line.
Properly place all wires and wire nut connections into the junction box, place the fixture base onto the mounting plate, and secure it in
place by re-tightening the set screws (reversal of step 1A).
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A
Install the Fixture
4
3
6
5
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
CEILING COLLECTION
MOUNTING PLATE
FIXTURE BASE
5
4
3
ALLEN WRENCH
SET SCREW
#8-32 SCREW