Installation Sheet
1A
Install the Fixture
2
1
Remove all the Allen screws around the canopy using the provided Allen Wrench.
Remove the mounting plate from the canopy.
Secure the mounting plate to the electrical box with the #8-32 screws.
Connect the blue driver wire to the black fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the black driver wire to the hot power line wire with a wire nut.
Neatly place the drivers, all wires, and wire nut connections inside the canopy, align the canopy holes with the mounting plate
holes, and secure the canopy in place by tightening the Allen screws using the provided Allen Wrench. NOTE: The driver must be
oriented in the canopy so that the tabs align with the slots on the mounting plate when installing the canopy to the
mounting plate.
Install the glass by carefully screwing it into the base. Repeat for remaining glass.Do not over tighten.
2
3
4
5
6
7
8
9
GLASS
ALLEN SCREW
ALLEN WRENCH
DRIVER
MOUNTING PLATE
#8-32 SCREW
CANOPY
10
10
NOTE: Installation for the Mara shown.
Installation is the same for the Spur.
TABS
SLOT