Installation Sheet

3
2
4
1
Installation Instructions for
Loom 14 Flush
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing
NEC compliant junction boxes.
This product is suitable for damp locations.
This product can be dimmed with a low voltage electronic dimmer.
This instruction shows a typical installation.
Remove the diffuser by unscrewing the finial located in the center of the fixture.
Connect the black driver wire to the hot power line wire with a wire nut.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the fixture to suitable ground in accordance with local electrical codes.
Properly place the driver, wires and wire nut connections into the electrical box. To assist with install, remove tape backing(Optional:
from driver and adhere to the electrical box or back of fixture housing.)
Install the fixture onto the electrical box with the two #8-32 screws provided.
Replace the diffuser onto the fixture. (Reversal of step 1.)
1
2
1A
Install the Fixture
3
4
5
6
1
DIFFUSER
FIXTURE
FINIAL
7
DRIVER
6
CEILING COLLECTION
920FMLOOM
1.0
700FMLOM
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!