Installation Sheet

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic

dimmer, TRIAC dimmer, or a 0-10V dimmer depending on

the wiring configuration.

This instruction shows a typical installation.

CEILING COLLECTION

Install the Fixture

Separate the crossbar assembly from the fixture base by

unscrewing and removing the two fixture screws.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

CROSSBAR

ASSEMBLY

2 2

#8-32

SCREW

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

CROSSBAR

ASSEMBLY

FIXTURE

BASE

1.2

Finch Float and Flush Square or Round Ceiling ( )LED

700 _-FMFIN LED

920FMFINCH

FIXTURE

SCREW

Note: If necessary, loosen the nut on the crossbar

to adjust it to the desired position.

PAGE 1
920FMFINCH Installation Instructions for Finch Float and Flush Square or Round Ceiling (LED) 700FMFIN_-LED 1.2 CEILING COLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. This product is suitable for damp locations. This product may be dimmed with a low-voltage electronic dimmer, TRIAC dimmer, or a 0-10V dimmer depending on the wiring configuration.
PAGE 2
1C CROSSBAR ASSEMBLY 3 5 FIXTURE BASE 4 6 6 3 Connect the fixture to a suitable ground in accordance with local electrical codes. 4 Connect the white driver wire to the neutral power line. 5 Connect the black driver wire to the hot power line. 6 Use the gray and purple dimming wires for 0-10V dimming application. SAVE THESE INSTRUCTIONS! NOTE: The purple and gray wires are only used for 0-10v dimming. For all other applications, cap off and do not connect the gray and purple wires.