Installation Sheet

2
Install the Fixture
2A
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the black driver wire to the hot power line wire
with a wire nut.
Connect the white driver wire to the neutral power line
wire with a wire nut.
For 0-10V dimming, use the purple and gray wires to
connect to a compatible dimmer.
Place all wires and wire nut connections inside the
fixture base.
Reinstall the fixture housing to the mounting plate
using the fixture screws (reversal of step 1A).
1
2
3
4
5
Squeeze the housing tabs and rotate theLED LED
housing to the desired position.
WARNING: Always squeeze the two tabs
when adjusting the housing. Failure to doLED
so will damage the finish.
Adjust the Module
3A
1
SAVE THESE INSTRUCTIONS!
1
2
3
LED HOUSING
COVER
LENS
OPTIC
4A
Unscrew and remove the housing cover.LED
Remove the optic.
If installing an optional lens, rest the lens inside the
housing cover.
Install the optic (replacement or existing) inside the LED
housing cover.
Screw the housing cover back on.LED
Optics and Lenses
4
5
3
2
1
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2017 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
4
6