Installation Sheet

Installation Instructions for

CEILING COLLECTION

Install the Mounting Plate

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Secure the mounting plate to the electrical box with the

two provided #8-32 screws.

1.0

Exo Single Ceiling

700FMEXO_-LED

920FMEXO

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer, 0-10V dimmer or TRIAC dimmer.

This instruction shows a typical installation.

FIXTURE

SCREW

Remove the fixture screws located on both sides of the

fixture housing using the provided Allen wrench.

Remove the mounting plate from the fixture base.

ALLEN

WRENCH

FIXTURE HOUSING

MOUNTING PLATE

#8-32 SCREW

PAGE 1
920FMEXO Installation Instructions for Exo Single Ceiling 700FMEXO_-LED 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer, 0-10V dimmer or TRIAC dimmer.
PAGE 2
Install the Fixture Optics and Lenses 2A 4A 1 2 3 4 LENS OPTIC LED HOUSING COVER 1 Connect the fixture to a suitable ground in accordance with local electrical codes. 1 Unscrew and remove the LED housing cover. 2 Remove the optic. 2 Connect the black driver wire to the hot power line wire with a wire nut. 3 3 If installing an optional lens, rest the lens inside the housing cover. Connect the white driver wire to the neutral power line wire with a wire nut.