Specification Sheet

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Seguro 1 Light FreeJack Pendant with Smoke Crackled Glass Shade

Feed the fixture coaxial cable through the glass shade.

Slide the glass shade down the cord and rest it onto the

socket assembly.

Cut the coaxial cable to the desired length.

Installation Instructions for

Seguro

920FJSGROP

Adjust the Fixture Height

GLASS SHADE

SOCKET ASSEMBLY

FIXTURE COAXIAL

CABLE

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

1.0

700FJSEG

Summary of content (4 pages)

PAGE 1
Installation Instructions for 920FJSGROP 700FJSEG Seguro 1.0 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust the Fixture Height 1B 1A FIXTURE COAXIAL CABLE ALLEN WRENCH SET SCREW 3 GLASS SHADE 3 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
1D 1H ALLEN WRENCH INNER WIRE 7 12 11 SIGHT HOLE 6 Cut the coaxial cable to the desired length. 7 Gently twist the end of the coaxial cable between thumb and forefinger. 11 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 1E 12 SURFACE Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.
PAGE 3
Install the Lamp 2A 2B GLASS SHADE GLASS SHADE SOCKET 2 SOCKET LAMP NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 1 NOTE: Use only your fingers and a soft cloth to install the lamp. Lift the glass shade up to expose the socket. Use MAX 35 Watt,Type Xelogen (Xenon) Bi-Pin Lamp. 2 Push the lamp pins completely into the socket holes. WARNING: RISK OF FIRE Never replace a Xenon (Xelogen) lamp with a regular Halogen lamp.
PAGE 4
2C GLASS SHADE SAVE THESE INSTRUCTIONS! SOCKET 3 Lower the glass shade onto the socket assembly. 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.