Installation Sheet

ManualsBrandsTech Lighting ManualsCeiling FixturesTech Lighting 1 Light LED ADA Compliant Flush Mount Ceiling Fixture from the Cirque Collection

1.8

Installation Instructions for

Cirque Small ( )LED

700 _-CQS LED

920CIRQSMD

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp or wet locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This product may be ceiling or wall mounted.

This instruction shows a typical installation.

CEILING COLLECTION

Install the Fixture Base

While supporting the glass shade, loosen (Do Not

Remove) the four #6-32 set screws on the fixture base

with the 1/16 Allen wrench.

Carefully remove the glass out of the fixture base.

#6-32 SET SCREWS

1/16 ALLEN

WRENCH

GLASS SHADE

FIXTURE BASE

Remove the mounting plate from the assembly by

unscrewing the two knurled nuts.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920CIRQSMD Installation Instructions for Cirque Small (LED) 700CQS_-LED CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp or wet locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
1E 1C 5 4 9 DRIVER 10 10 4 Connect the black driver wire to the hot power line wire with a wire nut. 9 Feed the red transformer wires through the hole in the center of the fixture. 5 Connect the white driver wire to the neutral power line wire with a wire nut. 10 Mount the fixture base to the ceiling by reinstalling it onto the mounting plate and secure it tightly with the knurled nuts.
PAGE 3
1G 13 For wet location installation, caulk around the fixture base with waterproof construction sealant. Install the Shade 2A FIXTURE BASE #6-32 SET SCREWS 1 2 GROOVE ON GLASS SHADE 1/16 ALLEN WRENCH 1 Place the glass shade into the fixture base until the grooved section of the glass shade is completely inside. 2 Hold the glass shade in place and tighten all four #6-32 set screws with the 1/16 Allen wrench to lock the glass shade in place.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2015 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.