Installation Sheet

2
1E
Properly place all wires and wire nut connections into
the electrical box, mount the fixture base to the ceiling
by reinstalling it onto the mounting plate, and secure it
tightly with the knurled nuts.
8
8 8
1D
Ground the mounting plate in accordance with local
electrical codes.
Connect the black fixture wire to the hot power line
wire with a wire nut.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
5
6
7
5
6
7
Place the glass shade into the fixture base until the
grooved section of the glass shade is completely inside.
Hold the glass shade in place and tighten all the #6-32
set screws with the 1/16 Allen wrench to lock the glass
shade in place.
1
2A
2
1/16 ALLEN
WRENCH
#6-32 SET SCREWS
GROOVE ON
GLASS SHADE
FIXTURE BASE
1
Install the Shade
2
1F
9
For wet location installation, caulk around the fixture
base with waterproof construction sealant.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
847.410.4400
www.techlighting.com
© 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company