Installation Sheet

Installation Instructions for

Cirque Small ( )LED

920FMCIRQSMD

Remove the mounting plate from the fixture base by

unscrewing the two knurled nuts.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Fixture Base

While supporting the glass shade, loosen (Do Not

Remove) all the #6-32 set screws on fixture base with

the 1/16 Allen wrench.

Carefully remove the glass out of the fixture base.

#6-32 SET SCREWS

1/16 ALLEN

WRENCH

GLASS SHADE

FIXTURE BASE

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for wet locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This product may be ceiling or wall mounted.

This instruction shows a typical installation.

NOTE: Install the mounting plate so that the studs

are parallel or perpendicular to the walls, this will

ensure that the fixture is oriented to the room.

#8-32 SCREW

MOUNTING PLATE

#8-32 SCREW

Secure the mounting plate to the electrical box with 2

#8-32 screws.

2.0

700 S_- 700 _-CQ LED, OWCQS LED

PAGE 1
920FMCIRQSMD Installation Instructions for Cirque Small (LED) 700CQS_-LED, 700OWCQS_-LED 2.0 GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for wet locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
1F 1D 5 6 7 9 For wet location installation, caulk around the fixture base with waterproof construction sealant. Install the Shade 5 2A Ground the mounting plate in accordance with local electrical codes. 6 Connect the black fixture wire to the hot power line wire with a wire nut. 7 Connect the white fixture wire to the neutral power line wire with a wire nut.