Installation Sheet

ManualsBrandsTech Lighting ManualsIndoor Ceiling Fixtures1 Light LED ADA Compliant Flush Mount Ceiling Fixture from the Cirque Collection

CEILING COLLECTION

Install the Fixture

#6-32 SET SCREWS

1/16 ALLEN

WRENCH

GLASS SHADE

FIXTURE BASE

While supporting the glass shade, loosen (Do Not

Remove) the four #6-32 set screws on fixture base with

the 1/16 Allen wrench.

Carefully remove the glass out of the fixture base.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp or wet locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This fixture may be ceiling or wall mounted.

This instruction shows a typical installation.

Remove the mounting plate from the assembly by

unscrewing the two knurled nuts.

MOUNTING

PLATE

1.8

Installation Instructions for

Cirque Large ( )LED

700 _-CQL LED

920CIRQLGD

KNURLED NUT

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920CIRQLGD Installation Instructions for Cirque Large (LED) 700CQL_-LED 1.8 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. This product is suitable for damp or wet locations.
PAGE 2
KNURLED NUT 1E 1C 10 5 4 9 DRIVER 10 4 Connect the black driver wire to the hot power line wire with a wire nut. 9 Feed the red transformer wires through the hole in the center of the fixture. 5 Connect the white driver wire to the neutral power line wire with a wire nut. 10 Mount the fixture base to the ceiling by reinstalling it onto the mounting plate and secure it tightly with the knurled nuts.
PAGE 3
1G For wet location installation, caulk around the fixture base with waterproof construction sealant. 13 Install the Shade 2A FIXTURE BASE #6-32 SET SCREW 1 2 GROOVE ON GLASS SHADE 1/16 ALLEN WRENCH 1 Place the glass shade into the fixture base until the grooved section of the glass shade is completely inside. 2 Hold the glass shade in place and tighten all four #6-32 set screws with the 1/16 Allen wrench to lock the glass shade in place.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2015 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.