Installation Sheet
1.4
Installation Instructions for
Boxie Large
1
920BOXILG
Install the Fixture
1A
1
2
#6-32 SET SCREWS
1/16 ALLEN
WRENCH
GLASS SHADE
FIXTURE BASE
While supporting the glass shade, loosen (Do Not
Remove) the #6-32 set screws on fixture base with the
1/16 Allen wrench.
Carefully remove the glass out of the fixture base.
1
2
1B
Remove the mounting plate from the assembly by
unscrewing the two knurled nuts.
3
MOUNTING
PLATE
KNURLED NUT
GP I :ENERAL RODUCT NFORMATION
This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
This product is suitable for damp or wet locations.
This product can be dimmed with a standard incandescent
dimmer.
This product is may be ceiling or wall mounted
This instruction shows a typical installation..
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1.5
700 _, 700BXL OWBXL_