Installation Guide

3
Loosen (do not remove) the set screws on the canopy
strain relief on the side which needs adjusting.
Evenly and gently pull out or push in the coaxial cable,
in very small increments, through the strain relief to
adjust whichever side to level the fixture.
Ensure that the fixture is level and re-tighten the set
screw on the strain relief.
STRAIN RELIEF
1
4A
CAUTION: Make sure to support the fixture if fine
leveling is necessary
2
2
Additional Leveling (optional)
NOTE: If necessary, minor leveling adjustments
to the fixture may be needed. It is
recommended that one person hold the fixture
straight with the use of a level while the other
adjusts the coaxial cable.
CAUTION: Only pull out extra cable for leveling
if enough cord was left being the canopy.
Minimal amounts of cord should be pulled out
for fine leveling.
3
1