Installation Guide

3A
2
4"
Leave 8" of the coaxial cable behind the canopy for the
power connections and fine leveling. Cut the excess
cord.
From the end of the coaxial cable, cut and remove 4" of
the insulation using a sharp knife. Make sure not to
nick the inner wires.
Strip the end of the inner wires.
Reconnect the power cord wires to their original
connections (reversal of 2A).
2C
6
7
8
9
Place all wires and wire nut connections properly inside
the canopy.
Align the canopy center hole with the crossbar center
hole.
Slide the canopy up against the ceiling and secure it in
place by tightening the decorative bolt.
DECORATIVE
BOLT
3B
5
6
Install the Fixture
Connect the fixture ground wire to a suitable ground in
accordance with local electrical codes.
Connect the black driver wire to the hot power line wire
with a wire nut.
Connect the white driver wire to the neutral power line
wire with a wire nut.
CANOPY
1
2
3
1
2
3
4
CANOPY
Using the provided Allen wrench, loosen (Do Not
Remove) the set screw on each strain relief.
Place the fixture on a level surface.
Evenly pull the three coaxial cables through the canopy
until it reaches the length desired. Take caution toNOTE:
not remove the inner bushing from inside the strain
relief while pulling the coaxial cord through.
Ensure that the canopy is level and re-tighten the set
screws on the strain reliefs.
2B
2
COAXIAL
CABLE
STRAIN
RELIEF
SET SCREW
3
4
5
ALLEN
WRENCH