Installation Guide

ManualsBrandsTech Lighting ManualsPendantsTech Lighting Bodiam 3000K LED Pendant with Linear Spread Diffuser

Installation Instructions for

Bodiam

Prepare the Canopy

#8-32

SCREW

CROSSBAR

Mount the crossbar assembly to the electrical box with

the two provided #8-32 screws.

Remove the crossbar from the canopy by completely

unscrewing the decorative bolt.

920LSBODIAM

GP I :ENERAL RODUCT NFORMATION

This fixture is intended to be installed utilizing NEC

compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

Adjust the Height (optional)

DECORATIVE

BOLT

CROSSBAR

CANOPY

2 2

1.0

700BOD_

SUSPENSION

Take note of the wire connections and remove the wire

nuts to disconnect the coaxial cord wires from the driver

wires.

POWER CORD WIRES

DRIVER WIRES

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920LSBODIAM Installation Instructions for Bodiam 700BOD_ 1.0 SUSPENSION GENERAL PRODUCT INFORMATION: This fixture is intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product may be dimmed with a low-voltage electronic dimmer. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Install the Fixture 2B 3A ALLEN WRENCH CANOPY 1 SET SCREW COAXIAL CABLE 2 Using the provided Allen wrench, loosen (Do Not Remove) the set screw on each strain relief. 3 Place the fixture on a level surface. 4 Evenly pull the three coaxial cables through the canopy until it reaches the length desired. NOTE: Take caution to not remove the inner bushing from inside the strain relief while pulling the coaxial cord through.
PAGE 3
Additional Leveling (optional) NOTE: If necessary, minor leveling adjustments to the fixture may be needed. It is recommended that one person hold the fixture straight with the use of a level while the other adjusts the coaxial cable. CAUTION: Only pull out extra cable for leveling if enough cord was left being the canopy. Minimal amounts of cord should be pulled out for fine leveling.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2015 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.