Installation Sheet

1A
Install the Fixture
N
H
2
1
Remove all the Allen screws using the provided Allen Wrench.
Remove the mounting plate and drivers from the canopy.
Secure the mounting plate to the electrical box with the #8-32 screws.
Feed the half ball/upper stem assembly through the top of the canopy.
Determine the desired height of the fixture using the provided stems and assemble them by screwing them together.
Feed the fixture wires through the stem assembly, then screw the stem assembly to the top of the fixture.
Feed the fixture wires through the half ball/upper stem assembly and canopy, then screw the half ball/upper stem assembly onto
the stem assembly.
Connect black wire of driver 1 to solid black fixture wire and the black wire of driver 2 to striped black fixture wire with a wire nut.
Connect red wire of driver 1 to a solid red fixture wire and red wire of driver 2 to a striped red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wires to the neutral power line wire with a wire nut.
Connect the black driver wires to the hot power line wire with a wire nut.
For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming,
cap off the purple and gray wires.
Neatly place the drivers, all wires, and wire nut connections inside the canopy, align the canopy holes with the mounting plate
holes, and secure the canopy in place by tightening the Allen screws using the provided Allen Wrench.
2
3
4
5
6
7
8
9
10
11
12
13
CANOPY
STEM ASSEMBLY
HALF BALL/
UPPER STEM
FIXTURE
N
H
ALLEN
SCREW
CANOPY
MOUNTING
PLATE
#8-32
SCREW
5
7
5
ALLEN
WRENCH
DRIVER
4
14