Installation Sheet

2
2
1
With the provided Allen wrench, remove the Allen screws on the top and the bottom of the fixture base.
Remove the mounting plate from the fixture base
Connect the black driver wire to the black fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: If using 0-10V dimming, connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming,
cap off the purple and gray wires.
Properly place the driver, all wires, and wire nut connections into the junction box, then install the mounting plate to the junction box
with the two #8-32 screws provided.
Mount the fixture base onto the mounting plate and secure it in place by reinstalling the Allen screws using the provided Allen wrench.
1A
Install the Fixture
4
3
6
5
7
9
8
ALLEN WRENCH
7
6
MOUNTING PLATE
JUNCTION BOX
DRIVER
#8-32 SCREW
5
ALLEN SCREW
10