Installation Sheet

2
1
With the provided Allen wrench, remove the Allen screws on the fixture base.
Remove the mounting plate from the fixture base
Connect the black/blue driver wire to the black/blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: Connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming, cap off the purple and gray
wires.
Properly place the driver, all wires, and wire nut connections into the junction box, then install the mounting plate to the junction box
with the two #8-32 screws provided. NOTE: T24 models will have driver mounted inside fixture base, minimum 4” junction
box is required otherwise.
Mount the fixture base onto the mounting plate and secure it in place by reinstalling the Allen screws using the provided Allen wrench.
1A
Install the Fixture
4
3
6
5
7
9
8
7
6
ALLEN WRENCH
& SCREW
JUNCTION BOX
MOUNTING PLATE
4
3
FIXTURE
BASE
DRIVER
10
5
8
2
©2020 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting.
Tech Lighting reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.techlighting.com