Installation Sheet

Installation Instructions for

920BCBANDA36

Banda 36 Bath

WALL

1.0

700BCBND36

1.2

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

Minimum 4” junction box is required for the standard

version. The driver is mounted within the fixture base

for the T24 version.

This product is suitable for damp locations.

T24 version of this product can be dimmed with most

ELV or TRIAC dimmers. Non-T24 version of this product

can be dimmed with TRIAC dimmers only.

SAVE THESE INSTRUCTIONS!

PAGE 1
920BCBANDA36 Installation Instructions for Banda 36 Bath 700BCBND36 1.0 1.2 WALL CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. GENERAL PRODUCT INFORMATION: Use minimum 90°C supply conductors. These fixtures are intended to be installed utilizing NEC compliant junction boxes. Minimum 4” junction box is required for the standard version.
PAGE 2
Install the Fixture 1A JUNCTION BOX ALLEN WRENCH & SCREW 6 5 8 FIXTURE BASE 7 ER IV DR 3 4 MOUNTING PLATE 1 With the provided Allen wrench, remove the Allen screws on the fixture base. 2 Remove the mounting plate from the fixture base 3 Connect the black/blue driver wire to the black/blue fixture wire with a wire nut. 4 Connect the red driver wire to the red fixture wire with a wire nut. 5 Connect the fixture to a suitable ground in accordance with local electrical codes.