Installation Sheet

2
1
With the provided Allen wrench, remove the set screw on the bottom of the fixture base.
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Connect the black driver wire to the black fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 0-10V Dimming Only: Connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming, cap off the purple
and gray wires.
Properly place the driver, all wires, and wire nut connections into the junction box, mount the fixture base onto the mounting plate, and
secure it in place by reinstalling the set screw using the provided Allen wrench. Note: minimum 4” junction box is required.
1A
Install the Fixture
4
3
6
5
7
9
8
10
ALLEN WRENCH
& SET SCREW
DRIVER
MOUNTING PLATE
JUNCTION BOX
#8-32 SCREW
2
©2020 Tech Lighting, L.L.C. All rights reserved. The Tech Lighting logo is a registered trademark of Tech Lighting.
Tech Lighting reserves the right to change specifications for product improvements without notification.
7400 Linder Ave., Skokie, IL 60077
T 847.410.4400 | F 847.410.4500
www.techlighting.com