Installation Sheet

Installation Instructions for

920BCBANDA

Banda 24 Bath

WALL

1.0

700BCBND24

1.1

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

Minimum 4” junction box is required.

This product is suitable for damp locations.

This product can be dimmed with most ELV or TRIAC

dimmers.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

PAGE 1
920BCBANDA Installation Instructions for Banda 24 Bath 700BCBND24 1.0 1.1 WALL CAUTION - RISK OF FIRE GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. Minimum 4” junction box is required. This product is suitable for damp locations. This product can be dimmed with most ELV or TRIAC dimmers. This instruction shows a typical installation.
PAGE 2
Install the Fixture 1A MOUNTING PLATE JUNCTION BOX DRIVER #8-32 SCREW ALLEN WRENCH & SET SCREW 1 With the provided Allen wrench, remove the set screw on the bottom of the fixture base. 2 Remove the mounting plate from the fixture base 3 Install the mounting plate to the junction box with the two #8-32 screws provided. 4 Connect the black driver wire to the black fixture wire with a wire nut. 5 Connect the red driver wire to the red fixture wire with a wire nut.