Installation Sheet

SAVE THESE INSTRUCTIONS!

Installation Instructions for

920BCBAU

Bau 24 Vanity

BATH

1.0

700BCBAU24

1.0

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with

the construction and operation of the product and the

hazards involved.

Use minimum 90°C supply conductors.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for indoor locations.

This product can be dimmed with a standard electronic

dimmer.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

PAGE 1
920BCBAU Installation Instructions for Bau 24 Vanity 700BCBAU24 1.0 BATH GENERAL PRODUCT INFORMATION: This product is suitable for indoor locations. This product can be dimmed with a standard electronic dimmer. This instruction shows a typical installation. SAVE THESE INSTRUCTIONS! CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Install the Fixture 1A JUNCTION BOX #8-32 SCREW 6 5 DRIVER 7 3 4 MOUNTING PLATE ALLEN SCREW ALLEN WRENCH 1 With the provided Allen wrench, remove the Allen screws on the fixture base. 2 Remove the mounting plate from the fixture base 3 Connect the black/blue driver wire to the black/blue fixture wires with a wire nut. 4 Connect the red driver wire to the red fixture wires with a wire nut. 5 Connect the fixture to a suitable ground in accordance with local electrical codes.