Installation Instructions

Installation Instructions for

ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. LED version may be dimmed with a LED dimmer. Consult

lamp manufacturer for additional information.

1.1

Install the Mounting Plate

CANOPY

Separate the mounting plate assembly from the canopy

by unscrewing the four mounting plate screws on the

canopy.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

MOUNTING

PLATE SCREW

Remove the mounting plate from the canopy.

MOUNTING PLATE

CANOPY

Secure the mounting plate to the electrical box with the

two #8-32 screws provided.

MOUNTING

PLATE

#8-32 SCREW

2 Linear

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

GP I :

PAGE 1
Installation Instructions for 2 Linear 1.1 GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
PAGE 2
Assemble the Fixture 1D FIXTURE WIRES 2A HANG STRAIGHT ALLEN WRENCH 4 SET SCREW 4 5 2 STEM 4 Line up an anchors with the center of a backplate holes and push the anchors in, up to the threads. 5 Screw the anchors the rest of the way in with a screwdriver. 2 1E FIXTURE 3 NOTE: Complete next steps for each side of the fixture. 6 6 6 Secure the backplate to the anchors with screws and washers. 2 1 Loosen the set screw on the hang straight using the provided Allen wrench.
PAGE 3
Install the Fixture Install the Lamps 3A 4A LAMP 12" SOCKET 1 Leave 12" of the cord behind the canopy for power connections. Cut the excess cord. 2 Strip the end of the wires. C AUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture. Refer to fixture marking for lamp information. 1 3B ELECTRICAL BOX 5 6 MOUNTING PLATE 7 3 Connect the ground wire to a suitable ground in accordance with local electrical codes.
PAGE 4
SAVE THESE INSTRUCTIONS! 4