Installation Instructions

2
2A
Unscrew the cap from the Fusion Jack adapter.
Select a place on the 2-Circuit Monorail where the fixture is
going to be mounted.
From the top place the Fusion Jack adapter onto the 2-Circuit
Monorail.
Replace and tighten the cap to the Fusion Jack adapter. Make
sure that the cap is not cross threaded.
1
2
3
4
CAP
FUSION JACK
ADAPTER
2-CIRCUIT MONORAIL
1
2B
Push and screw the fixture Fusion Jack completely into the
Fusion Jack adapter.
5
5
3
4
2C
M3 SET SCREW
CIRCUIT #1:
COMBINATION
OF THESE RAILS
WARNING: Use only circuit #1 when installing the
fixture as an up light. There is 24V between the middle
and top rail of the 2-Circuit Monorail.
To power up the fixture, tighten the M3 set screw on bottom
of the cap with the 1.5MM Allen wrench. Make sure that the
set screw is tight for proper power connection.
6
6
FIXTURE
FUSION JACK
FUSION JACK
ADAPTER
2
1.5 MM ALLEN
WRENCH
SAVE THESE INSTRUCTIONS!
Install the Adapter onto the 2-Circuit
Monorail for Up Light Fixtures