Installation Instructions

ManualsBrandsTech Lighting ManualsLighting1 - Light Unique / Statement Globe Pendant

Installation Instructions for

Two-Circuit Monorail Fusion Jack Adapter

1.0

PENDADAPMONOFJ2_

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Fusion 2-Circuit Monorail

Install the Adapter onto the 2-Circuit

Monorail for Down Light Fixtures

Unscrew the cap from the Fusion Jack adapter.

Select a place on the 2-Circuit Monorail where the fixture is

going to be mounted.

From the bottom place the Fusion Jack adapter onto the

2-Circuit Monorail.

Replace and tighten the cap to the Fusion Jack adapter.

Make sure that the cap is not cross threaded.

CAP

FUSION JACK

ADAPTER

2-CIRCUIT MONORAIL

Push and screw the fixture Fusion Jack completely into the

Fusion Jack adapter.

FIXTURE

FUSION JACK

ADAPTER

To power up the fixture from circuit #1, tighten the M3 set

screw on top of the cap with the 1.5MM Allen wrench. Make

sure that the set screw is tight for proper power

connection.

M3 SET SCREW

1.5 MM ALLEN

WRENCH

CIRCUIT #1:

COMBINATION

OF THESE RAILS

M3 SET SCREW

CIRCUIT #2:

COMBINATION

OF THESE RAILS

To power up the fixture from circuit #2, remove the M3 set

screw from top of the cap and screw it into the side of the

Fusion Jack adapter hole with the 1.5MM Allen wrench. Make

sure that the set screw is tight for proper power

connection.

NOTE: Never use more than one set screw to select

a circuit on the Fusion Jack adapter.

NOTE: Do not load either circuit over the maximum

system rating.

1.5 MM ALLEN

WRENCH

This product is intended to be used with 2-Circuit Mon

system.

Summary of content (2 pages)

PAGE 1
Installation Instructions for Two-Circuit Monorail Fusion Jack Adapter PENDADAPMONOFJ2_ 1.0 Fusion 2-Circuit Monorail GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product is intended to be used with system. 2-Circuit Mon Install the Adapter onto the 2-Circuit Monorail for Down Light Fixtures 1A 1 1C CAP M3 SET SCREW 6a 4 1.
PAGE 2
Install the Adapter onto the 2-Circuit Monorail for Up Light Fixtures 2C 2A 2-CIRCUIT MONORAIL FUSION JACK ADAPTER 3 2 4 1 CAP 1 Unscrew the cap from the Fusion Jack adapter. 2 Select a place on the 2-Circuit Monorail where the fixture is going to be mounted. 3 From the top place the Fusion Jack adapter onto the 2-Circuit Monorail. 4 Replace and tighten the cap to the Fusion Jack adapter. Make sure that the cap is not cross threaded.