Installation Instructions

CONICAL CONNECTOR

FIXTURE CONNECTOR

OUTER WRAPPED WIRE

Slide the outer wrapped wire back to expose the inner wire.

1/8"

INNER WIRE

M3 SET

SCREW

M4 SET

SCREW

INNER WIRE

2MM ALLEN WRENCH

1.5MM ALLEN WRENCH

Strip 1/8" from end of the inner wire. Make sure that the

stripped portion is not greater than 3/16".

Loosen (Do Not Remove) the M4 set screw with the

provided 2MM Allen wrench.

Remove the M3 set screw with the provided 1.5MM Allen

wrench.

INNER WIRE

M3 SET SCREW

1.5MM ALLEN WRENCH

While inserting the inner wire into the connector look

through the set screw hole to make sure that the stripped

portion of the inner wire contacts end of the connector.

Hold the coaxial cable in place; replace and tighten the M3 set

screw with the 1.5MM Allen wrench. Lightly tug on the

coaxial cable to make sure that the set screw connection is

tight.

2MM ALLEN WRENCH

M4 SET SCREW

STRAIN RELIEF

The strain relief slots should be rotated 90° away from the M4

set screw.

Slide and push the strain relief completely into the connector.

This will force the outer wrapped wire to be inserted into the

connector.

Tighten the M4 set screw with the 2MM Allen wrench so that

the strain relief holds the outer wrapped wire in place.

Slide the conical connector over the fixture connector. To

install the fixture, refer to the instructions provided with the

system.