Installation Instructions

1.1

HS447CRSC1B10FSJ

Fusion Jack™

Adjust the Fixture Height

Cut the coaxial cable to the desired length with a sharp cutter.

The overall fixture height (H) is measured from bottom of the

glass shade to the end of the coaxial cable.

CONICAL CONNECTOR

FIXTURE COAXIAL CABLE

Insert the fixture coaxial cable through the conical connector.

STRAIN RELIEF

Insert the coaxial cable through the flared end of the strain

relief.

(H)

COAXIAL CABLE

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

GLASS SHADE

PAGE 1
Installation Instructions HS447CRSC1B10FSJ 1.1 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust the Fixture Height 1A CONICAL CONNECTOR 1B FIXTURE COAXIAL CABLE COAXIAL CABLE 2 2 Insert the fixture coaxial cable through the conical connector. 1C (H) STRAIN RELIEF 3 1 3 GLASS SHADE 1 Cut the coaxial cable to the desired length with a sharp cutter.
PAGE 2
1D 1G OUTER WRAPPED WIRE 2MM ALLEN WRENCH M4 SET SCREW 11 12 4 10 INNER WIRE STRAIN RELIEF 4 Slide the outer wrapped wire back to expose the inner wire. 10 The strain relief slots should be rotated 90° away from the M4 1E set screw. 2MM ALLEN WRENCH 11 Slide and push the strain relief completely into the connector. 1.5MM ALLEN WRENCH This will force the outer wrapped wire to be inserted into the connector.
PAGE 3
Replace the Lamp & Shade 2B 2A 1 LAMP 1 2 GLASS SHADE LAMP NOTE: Use only your fingers and a soft cloth to install the lamp. NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. 1 SOCKET Use MAX 10 Watt Bi-Pin Xelogen (Xenon) Lamp. Gently remove the glass shade and old lamp from the socket assembly. 2 3 Push the lamp pins completely into the socket holes.