Installation & Assembly

3
2
1
Connect the fixture to a suitable ground in accordance
with local electrical codes.
Connect the white driver wire to the neutral power line
wire with a wire nut.
Connect the black driver wire to the hot power line wire
with a wire nut.
Install the Fixture
3A
3
1
2
Place all wires and wire nut connections inside the
canopy.
Align the canopy holes with the mounting plate holes.
Secure the canopy in place by tightening the four fixture
screws.
4A
3B
1
4
5
FIXTURE SCREW
Fine Leveling (Optional)
NOTE: If minor adjustments to the fixtures
leveling is necessary, it is recommended that one
person hold the fixture straight with the use of a
level while the other adjusts the coaxial cable
following the steps below.
NOTE: It is recommended that one person hold
the fixture while the electrician connects the
power and installs the canopy.
Using the provided Allen wrench, loosen (do not
remove) the set screws on the needed strain relief.
Gently pull or push the coaxial cable in very small
increments through the strain relief to lower one side of
the fixture until level.
Re-tighten the set screw on the strain relief.
2
3
3
55
COAXIAL
CORD
SET
SCREW
STRAIN
RELIEF
ALLEN
WRENCH