Installation & Assembly

2
1
Adjust the Height (optional)
6
Place the fixture on a level surface.
With the provided Allen wrench, loosen (do not remove)
the set screws on the strain reliefs.
Evenly pull the coaxial cables up through the strain
reliefs to raise the fixture to the desired height.
Ensure that the canopy is level and re-tighten the set
screws on the strain reliefs.
2
3
4
STRAIN RELIEF
SET SCREW
ALLEN WRENCH
6
2C
COAXIAL CORD
If shortening of the coaxial cords is necessary, take
note of the wire connections from the coaxial cables to
the driver and remove the wire nuts.
COAXIAL
CORD
DRIVER
WIRE
5
5
2D
7
Leave 6" behind for wire connections, cut off the excess
cord.
From the end of the cord, strip the insulation 4" using a
sharp knife. .Make sure not to nick the inner wires
Using the wire nuts, reconnect the wires to their original
connections.
7
8
9
8
9
1E
#8-32 SCREW
7
Re-install the back plate to the electrical box with two
#8-32 screws.
Secure the back plate to the anchors with the screws
and washers.
7
WASHERSCREW
6
6
7
7
7
2A
5
ALLEN WRENCH
2B
STRAIN RELIEF
Move the strain reliefs down the cable, leaving an inch
from the inside surface of the canopy for possible fine
leveling.
5
5
ALLEN WRENCH
ALLEN WRENCH
CAUTION: Do not over tighten to avoid shorting.