LBL Lighting Track System Buying Guide

WALL MONORAIL SYSTEM

Step One: Choose your decorative elements

Choose finish of system and make sure all components are specified

as such.

Choose elements (Heads) from decorative elements (pp. 9-10).

Determine item numbers. If using with a 24 volt transformer, specify

“-24” at the end of each element item number (pp. 138-169).

Specify one Wall Monorail Rail Adapter for each element (not

required for Mono-Arc and Mono-Tel Display Lights).

Add up total lamp wattage on system to confirm wattage does not

exceed transformer capacity.

Step Two: Choose your rail

Measure length of Wall Monorail run; determine quantity and length

of Wall Monorail sections required (p. 65).

Step Three: Choose your connectors

Use a Straight Conductive Connector for joining multiple pieces of

rail. Pair. (p. 65)

Straight Isolating Connectors join sections of Wall Monorail and

must be used when isolating one powered section from another.

Typically they are used to separate 2x300 watt sections when using

a 12 volt, 600 watt surface transformer. They must also be used

when multiple surface transformers or canopies are used on a

continuous run. Pair. (p. 65)

Use an Adjustable Angle Conductive Connector if the run includes a

sharp angle or turn. Pair. (p. 65)

Add End Caps to finish off the ends of the run. 4 pc. set. (p. 65)

(BZ) Bronze or (SC) Satin Nickel

H ____________________ FSJ

RAILADAP-WALL ____________

________________ watts

RAIL ____________________

SCONNECTOR ______________

ISOCONNECTORCL-M

ACONNECTOR ______________

ENDCAPS- ________________

QTY. ITEM NUMBER

Page numbers below reference the LBL Lighting Full Line Catalog (921LBLFLCAT09)