LBL Lighting Track System Buying Guide

2-CIRCUIT MONORAIL SYSTEM

Step One: Choose your decorative elements

Choose finish of system and make sure all components are specified

as such.

Choose elements (Pendants, Heads and Chandelier Heads) from

decorative elements (pp. 6-11).

Determine item numbers (pp. 68-173).

Add up total lamp wattage on system to confirm wattage does not

exceed transformer capacity.

Step Two: Choose your rail

Measure length of 2-Circuit Monorail run; determine quantity and

length of 2-Circuit Monorail sections required (p. 56).

For custom bent 2-Circuit Monorail, please provide the degree and

radius of each curve and/or a scaled drawing, by fax, to the quotes

department, 847-626-6325, for a quotation.

Step Three: Choose your connectors

Use a Straight Conductive Connector for joining multiple pieces of

rail. Set of three. (p. 57)

Use a “T” Conductive or “X” Conductive Connector for joining

pieces of rail into a “T” or “X” shape. Set of three. (p. 57)

Straight Isolating Connectors join sections of 2-Circuit Monorail

and must be used when isolating one powered section from

another. Typically they are used to separate powered sections when

using a dual feed canopy. They must also be used when multiple

surface transformers or canopies are used on a continuous run. Set

of three. (p. 57)

Use an Adjustable Angle Conductive Connector if the run includes a

sharp angle or turn. Set of three. (p. 57)

Add End Caps to finish off the ends of the run. 6 pc. set. (p. 57)

(BZ) Bronze or (SC) Satin Nickel

H____________________ MR2

________________ watts

RAIL ____________________-2

SCONNECTOR ____________-2

TCONNECTOR ____________-2

ISOCONNECTORCL-M-2

ACONNECTOR ____________-2

ENDCAPS ________________-2

QTY. ITEM NUMBER

Page numbers below reference the LBL Lighting Full Line Catalog (921LBLFLCAT09)