LBL Lighting Track System Buying Guide

MONORAIL SYSTEM

Step One: Choose your decorative elements

Choose finish of system and make sure all components are specified

as such.

Choose elements (Pendants, Heads and Chandelier Heads) from

decorative elements (pp. 6-11).

Determine item numbers. If using with a 24 volt transformer, specify

“-24” at the end of each element item number (pp. 68-173).

Add up total lamp wattage on system to confirm wattage does not

exceed transformer capacity.

Step Two: Choose your rail

Measure length of Monorail run; determine quantity and length of

Monorail sections required (p. 40).

For custom bent Monorail, please provide the degree and radius

of each curve and/or a scaled drawing, by fax, to the quotes

department, 847-626-6325, for a quotation.

Step Three: Choose your connectors

Use Straight Conductive Connectors for joining multiple pieces of

rail. Pair. (p. 41)

Use a “T” Conductive or “X” Conductive Connector for joining

pieces of rail into a “T” or “X” shape. Pair. (p. 41)

Straight Isolating Connectors join sections of Monorail and must be

used when isolating one powered section from another. Typically

they are used to separate 2x300 watt sections when using a 12 volt,

600 watt surface transformer or dual feed canopy. They must also be

used when multiple surface transformers or canopies are used on a

continuous run. Pair. (p. 41)

Use an Adjustable Angle Conductive Connector if the run includes a

sharp angle or turn. Pair. (p. 41)

Add End Caps to finish off the ends of the run. 4 pc. set. (p. 41)

(BZ) Bronze or (SC) Satin Nickel

H ____________________ MRL

________________ watts

RAIL ____________________

SCONNECTOR ______________

TCONNECTOR ______________

ISOCONNECTORCL-M

ACONNECTOR ______________

ENDCAPS- ________________

QTY. ITEM NUMBER

Page numbers below reference the LBL Lighting Full Line Catalog (921LBLFLCAT09)