LBL Lighting Track System Buying Guide

10
Step Four: Choose your connectors
Use a Straight Conductive Connector for joining multiple pieces of
LED Illuminated Monorail. Pair. (p. 21)
Straight Isolating Connectors join sections of LED Illuminated
Monorail and must be used when isolating one powered section
from another. Typically they are used to separate 2x300 watt
sections when using a 12 volt, 600 watt surface transformer or
dual feed canopy. They must also be used when multiple surface
transformers or canopies are used on a continuous run. Pair. (p. 21)
Add an LED End Cap to finish off one end of a run 16' or less where
one LED single generator is used (p. 21).
Step Five: Choose your supports
Recommended every 3' (p. 29).
Step Six: Choose your transformer + canopy*
Use a remote transformer and LED Illuminated Wall Monorail direct
feed canopy. Choose magnetic or electronic (pp. 26-27,29).
*If using LED heads or pendants, be sure to choose a transformer that is
compatible with LED fixtures.
SCONNECTOR ______________
ISOCONNECTORCL-M
ENDCAPS- __________ -M-LED
HANGERDIRW- __________-LED
TRANS-RMTE ______________
REMOTECNPDIRW- ______ -LED
QTY. ITEM NUMBER
Page numbers below reference the LBL Lighting Full Line Catalog (921LBLFLCAT09)
LED ILLUMINATED WALL MONORAIL SYSTEM