Installation Instructions

ManualsBrandsTech Lighting ManualsLighting1 - Light Single Teardrop Pendant

Installation Instructions for

Cypree Small & Large Pendant

1.0

HS46_1B50FSJ

980FSJCYPREP

Fusion Jack™

Adjust the Fixture Height

Feed the fixture coaxial cable through the glass shade. Slide the

glass shade down the cord and rest it onto the socket

assembly.

Cut the coaxial cable to the desired length with a sharp cutter.

The overall fixture height is measured from bottom of the glass

shade to end of the coaxial cable.

GLASS SHADE

SOCKET ASSEMBLY

FIXTURE COAXIAL

CABLE

CONICAL CONNECTOR

FIXTURE COAXIAL CABLE

Insert the fixture coaxial cable through the conical connector.

STRAIN RELIEF

Insert the coaxial cable through the flared end of the strain

relief.

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

Summary of content (4 pages)

PAGE 1
Installation Instructions for 980FSJCYPREP Cypree Small & Large Pendant HS46_1B50FSJ 1.0 Fusion Jack™ GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Adjust the Fixture Height 1A CONICAL CONNECTOR 1B FIXTURE COAXIAL CABLE FIXTURE COAXIAL CABLE 3 3 Insert the fixture coaxial cable through the conical connector.
PAGE 2
1D 1G OUTER WRAPPED WIRE 2MM ALLEN WRENCH M4 SET SCREW 12 5 13 11 INNER WIRE STRAIN RELIEF 5 Slide the outer wrapped wire back to expose the inner wire. 11 The strain relief slots should be rotated 90° away from the M4 1E set screw. 2MM ALLEN WRENCH 12 Slide and push the strain relief completely into the connector. 1.5MM ALLEN WRENCH This will force the outer wrapped wire to be inserted into the connector.
PAGE 3
Install the Lamp 2A 2B GLASS SHADE GLASS SHADE 1 2 SOCKET LAMP SOCKET 1 Lift the glass shade up to expose the socket. NOTE: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. NOTE: Use only your fingers and soft cloth to replace the lamp. Use MAX 50 Watt, Type Xelogen (Xenon) Bi-Pin Lamp. 2 Push the lamp pins completely into the socket holes. 4 WARNING: RISK OF FIRE Never replace a Xenon (Xelogen) lamp with a regular Halogen lamp.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2008 LBL Lighting. All rights reserved. The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.