Installation & Assembly

Installation Instructions for

Suspension

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product may be dimmed using a low-voltage electronic

dimmer.

Oma Pendant

980OMAP

1.0

L 953P

Install the Lamp

ALLEN WRENCH

PANEL SCREW

LOWER BRACKET

UPPER BRACKET

Remove the upper brackets by uninstalling the panel

screws using the provided Allen Wrench.

GLASS PANEL

UPPER

BRACKET

ALLEN WRENCH

PANEL SCREW

Place the glass panel onto the lower bracket followed by

the upper bracket and secure them together by

installing the panel screws using the provided Allen

Wrench. Repeat for remainingDo not over-tighten.

glass panels.

PAGE 1
Installation Instructions for 980OMAP Oma Pendant LP953 1.0 Suspension GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product may be dimmed using a low-voltage electronic dimmer. Install the Lamp 1A 1B ALLEN WRENCH PANEL SCREW ALLEN WRENCH PANEL SCREW UPPER BRACKET UPPER BRACKET LOWER BRACKET GLASS PANEL 1 2 Remove the upper brackets by uninstalling the panel screws using the provided Allen Wrench.
PAGE 2
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.323.3226 - 847.626.6300 www.lbllighting.com © 2017 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a registered trademark of LBL Lighting. LBL Lighting reserves the right to change specifications for product improvements without notification.